Routine maintenance 10 elements of dust collector

Dust collector is an important part of the environmental conditions of various units, dust collection efficiency and service life directly affect the effectiveness and image of the enterprise, whether the dust collector can maintain long-term efficient and stable operation, and extend its service life, routine maintenance and repair is essential. There are routine maintenance 10 elements of dust collector: 1. Managers should be familiar with the principle performance, conditions of use, and to master the adjustment and maintenance methods of dust collector. 2. Gear reducer, ash transport device and other mechanical moving parts should be specified oiling and oil change, found to have abnormal phenomena should be promptly excluded. 3. Oil and water separator in the gas tank and gas source triplet should be drained once per shift, while the oil-water separator should be cleaned once every 3 ~ 6 months. The oil mist eliminator should check the oil storage frequently and refuel it in time. 4. Electromagnetic pulse valve in the event of failure, should be promptly excluded, if have internal impurities or moisture, should be cleaned up, if have the diaphragm should be replaced promptly damaged. 5. Using the timing pulse controller should be measured periodically cleaning cycle is accurate, or should be adjusted. Using a constant pulse controller resistance, should regularly check the operation of the pressure switch, pressure port is blocked, and cleaned. 6. Periodic determination of process parameters, such as flue gas volume, temperature, concentration, etc., found abnormal, should find the reason and timely treatment. 7. Turn on the machine, you should first connect the compressed air to the gas tank, turn on the control power, start ash removal device, if there are other devices in the system, you should start downstream equipment. 8. When stopping, after the process system is stopped, keep the dust collector and exhaust fan to work for a period of time to remove the moisture and dust in the equipment. It must be noticed that when the dust collector stops working, the dust collector must be cleaned repeatedly (Available manual cleaning), remove the dust on the filter bag to prevent the impact of moisture and paste the bag. 9. When stopping, do not have to cut off the compressed air source, especially in the fan work, you must provide compressed air to the poppet valve to ensure that the poppet valve open at the state. 10. Dust collector in normal work, the ash discharge device can not stop working, otherwise, the ash bucket will soon be filled with dust overflow into the bag chamber, forcing the dust collector to stop working.