Installation steps and precautions of bag filter

The working principle of the bag filter is very simple, the main is the use of filter bag dust bag to hinder the industrial exhaust particulate matter, bag can intercept contaminable particles in the the exhaust gases into hopper, this can effectively prevent the pollution of particulate matter into the atmosphere polluting the atmosphere, to ensure that the environment is not polluted, so the bag filter is a dust removal equipment used in many enterprises, the practical effect is very strong. The bag filter is indispensable for a variety of industrial dust removal equipment, have good dust removal efficiency, so the following we first understand 9 installation steps and precautions of bag filter: 1. Before installing the bag filter, to check all attachments are complete, the host has no damage, all parts of the connection is solid, etc., if any problems should to be solved before installation. 2. Place the dust removal equipment to be flat, the bag filter installed in a cement foundation. 3. The upper box and the lower box need precise docking, the installation is firm, the seal should be done well. 4. Electromagnetic pulse valve and control box wiring, should be done in order, must leave the backup line. 5. In the compressed air inlet install oil-water separator, when installed, the filter must trap the air flow direction shown in line with the compressed air flow direction, the outlet pressure of the compressed air valve should be adjusted to 0.3 ~ 0.4MPa. 6. When installed the bag filter and skeleton, should fit well with the flower plate hole. 7. When the bag filter is installed outdoors, the electromagnetic pulse valve and pulse injection controller need to be secured to the canopy or hood. 8. Before putting into use, the equipment should be checked whether the fan running on the equipment is normal, whether there is any abnormal noise or bad condition, otherwise it should be shut down for repair. When debugging, you should first move the fan, observe the fan steering, to ensure that the fan can operate normally and turn to the correct time before put into use. 9. Turn on the pulse blowing controller to issue a command to turn on the electromagnetic pulse valve in order to observe whether the cleaning action is correct.