TD, TH, NE bucket elevator products are suitable for lifting from low to high. After the supplied materials are put into the hopper through the vibrating table, the machine automatically runs continuously and transports upwards. Bucket elevator is composed of hopper, driving device, top and bottom rollers, tape, tensioning device and casing, etc. It is suitable for lifting from low to high. After the supplied materials are put into the hopper through the vibrating table, the machine automatically runs continuously and transports upwards. The conveying speed can be adjusted according to the conveying volume, and the lifting height can be selected as required.

TD, TH, NE bucket elevators are maintained and managed by designated personnel, and the keys of the power switch box are managed by designated personnel. The bucket elevator utilizes a series of hoppers evenly fixed on the endless traction member, a continuous conveying machine that vertically lifts the material, and the bucket elevator utilizes a series of hoppers fixed on the traction chain or tape to vertically or nearly vertically. The bulk material is transported inward and upward in a straight direction. It is divided into three types: ring chain, plate chain and belt. TD, TH, NE bucket elevators must have a hoisting limiter and a travel limiter. The limiter should make the pulley stop automatically when it is lifted to a distance of 300 from the drum or pulley. The bucket elevator should have a large load sign, and the weight should not be overloaded during lifting and lowering (1 After power-on, inspect the safety devices such as the hoist limiter, travel limiter, interlock switch, etc., the action is sensitive and reliable, and the test is carried out. Before hoisting and landing, the car can be driven only after the bell rings. The hoist must never allow people to get on and off. After the work is completed, the hanging plate of the hoist should fall to the ground, then cut off the power supply, and close the upper and lower guardrail doors.

TD, TH, NE bucket elevators have low driving power, adopt inflow feeding, induced discharge, and large-capacity hopper intensive arrangement. There is almost no material returning and digging phenomenon when the material is lifted, so the ineffective power is small; lifting Wide range, this type of elevator has less requirements on the types and characteristics of materials. It can not only improve general powdery and small granular materials, but also improve materials with high abrasiveness. It has good sealing performance and less environmental infection; operation reliability Well, advanced design principles and processing methods ensure the reliability of the whole machine's operation, without failure) for more than 20,000 hours. Bucket Elevator Bucket elevator is composed of hopper, driving device, top and bottom rollers, tape, tensioning device and casing, etc. It is suitable for lifting from low to high. After the supplied material is put into the hopper through the vibrating table, the machine runs automatically and continuously. Ship up. High lifting height. The hoist runs smoothly, so it can reach a relatively high lifting height; the service life is long, the feeding of the hoist adopts the inflow type, no need to use the bucket to dig the material, and there is little extrusion and collision between the materials. TD, TH, NE bucket elevators are designed to ensure that materials are rarely scattered during feeding and unloading, reducing mechanical wear.

If the bucket elevator is not used for a period of time and needs to be disassembled and stored, what should we pay attention to when disassembling it? TD, TH, NE bucket elevators are not used every day in the production process, and often need to be changed or moved indoors after a period of use. At this point, it is necessary to disassemble the bucket elevator equipment. How to carry out safe and orderly disassembly work, how to ensure "installation and disassembly", without affecting the normal use of the equipment. The first thing to pay attention to when disassembling the bucket elevator is safety. Before dismantling the bucket elevator, the person in charge shall formulate a plan according to the installation drawing, and write a written charter for the dismantling, post-installation, sequence and placement of the bucket elevator.