Effect of Vibrating Feeder on Jaw Crusher Capacity
Date:2021-03-19 16:54:45
Author:admin
Views:
114
The jaw crusher is widely used in mining smelting, building materials, roads, railways, water conservancy and chemicals, etc., which are used for the breakage of various ore and bulk materials. The jaw crusher is generally used in the ore production line, which has an important impact on the production efficiency of the entire production line.
The feed is a first step in a crushing production line, and thereafter, it is often broken with jaw crusher and has an important impact on the production capacity of the molar. To improve the production capacity of the jaw crusher, you must first use the feeder correctly.
1. Strictly control the amount of feed.
Many producers always use the measured feed port size as the maximum feeding size, so that the feedstock is easy to card the cavity. Although not repeatedly blocked, each block is blocked, the equipment will not run properly for a long time. Therefore, strict control of the raw material particle size is one of the most important prerequisites that ensure the normal operation of the jaw crusher. Practice has proved that the maximum particle size of 0.8 ~ 0.9 times is 0.9 times the size of the feed port size, and the jaw is not easy to show the cavity and clogging the phenomenon.
2. Strictly control the amount of feed to prevent incurring phenomenon due to excessive production.
Many companies often have excessive feeds in order to increase the amount of devices that limit the amount of supply. Since the working principle of the molar is half-paced, if the excess material is put into excess material, it will cause the material to be broken, and the material after crushing can not be excluded in time, resulting in the gas. Therefore, excess feeds will affect the capacity of the ceremonies.
3. Control the feeding rhythm to ensure that the jaw is running normally.
Adjust the angle of feeder to avoid vertical. Delivery bus is directly discharged, the drawbacks of vertical materials are more serious. Therefore, it is necessary to adjust the angle of the lower silo to ensure smooth and non-compression, allowing the rhythm of the feeder and the process of the rhythm of the jaw crusher, is the technical guarantee of normal feed.
In addition, the horizontal stroke of the dynamic scale, the discharge layer, speed, and material humidity, etc. also affect the production capacity of jaw crusher, or by adjusting these factors to improve the bank production capacity.
